Brother BP2100 Operation Manual page 157
Embroidery machine
Hide thumbs
Also See for BP2100:
- Quick setup manual (32 pages) ,
- Manual de instrucciones (180 pages) ,
- Operation manual (180 pages)
Table of Contents
Advertisement
m
Gently pull the upper thread to bring the
bobbin thread up through the needle plate.
→ A loop of the bobbin thread comes out through the
hole in the needle plate.
n
Insert tweezers through bobbin thread loop
and pull bobbin thread above the needle
plate.
o
Align the upper thread and bobbin thread,
and then pull out about 10 cm (approx.
4 inches) of the threads and pass them
under the presser foot toward the rear of
the machine.
PREPARING FOR BOBBIN WORK
p
Install the needle plate cover and bobbin
cover with tabs.
For details on installing the needle plate cover, refer to
"Cleaning the Race" on page A-15.
a Bobbin cover
b Bobbin cover with tabs
CAUTION
• When creating bobbin work, use the bobbin
cover with tabs, otherwise the thread may
become tangled or the needle may break.
Note
• When installing the needle plate cover, do
not allow it to pinch the thread.
q
Install the embroidery unit.
Note
• When installing the embroidery unit, do not
allow it to pinch the thread.
• When the bobbin thread is replaced with a
new one, be sure to repeat the procedure
a
from
, otherwise the lower threading will
not be done correctly.
→ This completes the upper and lower threading.
A
1
Appendix A-7
- Quick Links:
- Embroidery Machine
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
