Brother BE-1204B Instruction Manual page 169
12 needle embroidery machine stand-alone type
Hide thumbs
Also See for BE-1204B:
- Instruction manual (262 pages) ,
- Maintenance schedule (9 pages) ,
- Supplement manual (2 pages)
Table of Contents
Advertisement
Code
Error Messages
Can not identify the
E-49
machine model
I/O CPU communication
E-4A
error
E-A1
Main (Z) motor lock
Main (Z) PCB
E-A2
temperature is too high
Main (Z) motor voltage
E-A3
is too low
Main (Z) motor voltage
E-A4
is too high
E-A5
Spindle CPU error
E-A6
ERROR A6
E-A7
ERROR A7
E-A8
ERROR A8
Spindle CPU parameter
E-A9
error
E-B0
Lower shaft CPU error
Thread jammed in
E-B1
rotary hook
Hook motor origin point
E-B2
error
Hook motor standby
E-B3
position error
Hook motor standby
E-B4
position error
Hook motor
E-B5
communication error
Hook motor parameter
E-B6
error
Hook motor overheat
E-B7
error
Hook motor overcurrent
E-B8
error Turn off the
power
Thread trimming motor
E-B9
origin point error
Power supply frequency
E-BA
error
E-BC
No power error
Error
Can not identify the machine
model
Failed in the communication with
I/O CPU
Spindle motor lock
Main PC board temperature too
high
Spindle motor voltage too low
Spindle motor voltage too high
Spindle motor CPU error
Spindle motor CPU communication
command error
Spindle motor CPU send/receive
error
Spindle stop position signal error
Spindle CPU parameter error
Lower shaft CPU error
Thread tangle in rotary hook
Hook motor origin point error
Hook motor standby position error
Hook motor motor mode error
Hook motor communication error
Hook motor parameter error
Hook motor overheat error
Hook motor overcurrent error
Thread trimming motor zero point
error
Power supply frequency error
No power error
BE-1204B-BC • BE-1206B-BC
Measures
Turn OFF the power, check if the model
identification harness is connected properly, and
turn ON the power again.
Press the
or turn ON the F/B switch on the
head to either side. If the same error occurs
again, the connector of communication cable on
the I/O PCB may be disconnected.
Press the
or turn on the F/B switch on the
head to either side. If it occurs frequently, the
main shaft mechanism is faulty.
This is not usually displayed.
Adjust the pulley stop position (100 °) above the
needle and press the
frequently, the parts related to the main shaft stop
position sensor are faulty.
This is not displayed in this model.
Turn the power off and on once. If the same
error occurs again, the lower shaft motor is faulty.
Turn the power off and check the thread trimmer
and turn the power on again. If it occurs again,
the thread trimmer is faulty.
It may usually occur momentarily when turning off
the machine. If it occurs when the machine is
on, it is a power failure detection error.
Chapter 9 Error code list
. If the error occurs
9-5
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
