Operating Procedures; Power Source; Preparation For Embroidering - Brother BE-1204B Instruction Manual
12 needle embroidery machine stand-alone type
Hide thumbs
Also See for BE-1204B:
- Instruction manual (262 pages) ,
- Maintenance schedule (9 pages) ,
- Supplement manual (2 pages)
Table of Contents
Advertisement
Chapter 6 Operation of Machine
1. Operating Procedures
1-1 Power Source
Main power switch
W1262Q
1.
Turn on the main power switch.
2.
Reset the emergency stop switch.
3.
Change the Flat / Cap hoop select switch on the operation panel according to the hoop to be used.
4.
Press the power switch.
5.
A message is displayed on the LCD.
6. The alarm sounds three times and the needle bar move upward.
home position and the sewing data screen is displayed.
When turning the power off and back it on again, wait for at least 10 seconds.
1-2 Preparation for Embroidering
1.
Select embroidering data.
2.
Pressing
An error message is displayed on the LCD if a pattern comes out of the hoop.
3.
Pressing
starts embroidering.
4.
After embroidering is finished, the machine is placed in the stand-by state.
6-2
Emergency stop switch
W1265Q
W1264Q
, determine a position to start embroidering.
BE-1204B-BC • BE-1206B-BC
Flat / Cap hoop select switch
W1404Q
Power switch
W1266Q
Then the hoop moves to the
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
