HP D7171A - NetServer - LPr Upgrade Kit

Power supply upgrade kit

Hide thumbs Also See for D7171A - NetServer - LPr:

Download this manual See also: Administrator's Manual, Service Manual

HP NetServer LC 2000r Power Supply Upgrade Kit

Installation Sheet

This sheet describes the steps you need to perform to install the HP NetServer Power Supply Upgrade Kit. The kit

adds an additional power supply module (PSM) to the PSM that come standard with the server. The additional PSM

allows the server to keep operating should the original PSM fail.

Installing the Power Supply

To install a power supply module (PSM) in the open bay of the power supply cage, follow these steps:

1. Loosen the thumbscrews from the filler panel of the open bay and remove the filler panel.

NOTE

You do not need to turn off power to the HP NetServer when you are adding a redundant power

supply because the PSM is a hot-swap module.

2. Set the new PSM in the open bay (see Figure 1).

CAUTION

Use two hands when lifting a PSM. Use one hand to hold the handle, and use the other to support

the weight of the PSM.

3. Push in the PSM, seat it firmly, and tighten the thumbscrews.

The PSM is now installed.

4. Install the AC power cord.

5. Check that the LED at the front of each power supply is shining green. This confirms that the power supply is

functioning.

HP Part Number 5969-2109

Printed in October 1999

Figure 1. Inserting the New Power Supply in the Open Bay