Redialing The Last Number Dialed; Storing And Retrieving A Call Using Call Park - Cisco 7912G User Manual
For cisco callmanager
Hide thumbs
Also See for 7912G:
- At-a-glance (20 pages) ,
- User manual (16 pages) ,
- Install manual (8 pages)
Table of Contents
Advertisement
Chapter 3
Placing a Call and Other Basic Phone Tasks
Step 3
Redialing the Last Number Dialed
Storing and Retrieving a Call Using Call Park
Step 1
Step 2
Step 3
Step 4
78-15080-02
When the call rings on the other end, press Trnsfer again. Or, when the party
answers, announce the call and then press Trnsfer.
If the party refuses the call, press the Hold button to return to the original call.
To redial the most recently dialed number, press the Redial softkey. Doing so
without lifting the handset activates the speaker.
Call Park allows you to retrieve an incoming call from another phone, such as a
phone in another office or in a conference room. Call park numbers are
pre-configured for this purpose by your system administrator.
Procedure
During an active call, press the more softkey until you see the Park tab.
Press the Park softkey. The LCD screen displays the special call park number at
which the call is stored. If the screen does not display a call park number, the call
park feature is not available to you.
Make a note of the call park number, then hang up. The call is parked at that
number, allowing you to retrieve it from another phone.
To retrieve the parked call from any phone in the Cisco CallManager system, dial
the call park number at which the call is parked.
Note
You have a limited amount of time to retrieve the parked call before it
reverts to ringing at its original destination. See your system
administrator for this time limit.
Cisco IP Phone 7905G/7912G User Guide for Cisco CallManager
Storing and Retrieving a Call Using Call Park
3-5
- Quick Links:
- How to Pick up Calls Within...
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
