Enabling Restrictions On Oversubscription Ratios; Configuring Bandwidth Fairness - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual
Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)
Hide thumbs
Also See for AP776A - Nexus Converged Network Switch 5020:
- Command reference manual (1640 pages) ,
- Configuration manual (1486 pages) ,
- Reference (886 pages)
Table of Contents
Advertisement
Chapter 15
Configuring Generation 2 and Generation 3 Switching Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
no rate-mode oversubscription-limit module 2 <---indicates no restrictions on
Save the new oversubscription ratio configuration to the startup configuration.
Step 7
switch# copy running-config startup-config
Enabling Restrictions on Oversubscription Ratios
You must enable restrictions on oversubscription ratios before you can downgrade modules to a previous
Caution
release.
Before enabling restrictions on oversubscription ratios, ensure that you have explicitly configured shared
ports to out-of-service mode. To enable restrictions on oversubscription ratios on a 48-port or 24-port
4-Gbps, or any 8-Gbps Fibre Channel switching module, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# interface fc2/1-2,
fc2/4-5, fc2/8-38, fc2/43-48
Step 3
switch(config-if)# shutdown
Step 4
switch(config-if)# out-of-service
Step 5
switch# rate-mode oversubscription-limit
module 1
Step 6
switch# config t
switch(config)# interface fc2/1-2,
fc2/4-5, fc2/8-38, fc2/43-48
switch(config-if)# no out-of-service
switch(config-if)# no shutdown
Step 7
switch(config)# exit
Step 8
switch# copy running-config startup-config
Configuring Bandwidth Fairness
This feature improves fairness of bandwidth allocation among all ports and provides better throughput
average to individual data streams. Bandwidth fairness can be configured per module.
OL-18084-01, Cisco MDS NX-OS Release 4.x
Configuring Module Interface Shared Resources
oversubscrption ratios
Purpose
Enters configuration mode.
Specifies the port interfaces for which you want to
enable restrictions on oversubscription ratios.
Shuts down shared ports.
Takes shared ports out of service.
Enables restrictions on oversubscription ratios for
the module.
You must enter this command separately for
Note
each module for which you want to add the
restriction.
Returns all shared ports to service.
Exits configuration mode.
Saves the new oversubscription ratio configuration
to the startup configuration, and then the new
configuration is enforced upon subsequent reboots
of the module.
Cisco MDS 9000 Family CLI Configuration Guide
15-45
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
