Management Interfaces; About Management Interfaces; Configuring Management Interfaces - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual
Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)
Hide thumbs
Also See for AP776A - Nexus Converged Network Switch 5020:
- Command reference manual (1640 pages) ,
- Configuration manual (1486 pages) ,
- Reference (886 pages)
Table of Contents
Advertisement
Management Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Management Interfaces
You can remotely configure the switch through the management interface (mgmt0). To configure a
connection on the mgmt0 interface, you must configure either the IP version 4 (IPv4) parameters (IP
address, subnet mask, and default gateway) or the IP version 6 (IPv6) parameters so that the switch is
reachable.
This section describes the management interfaces and includes the following topics:
•
•
•
About Management Interfaces
Before you begin to configure the management interface manually, obtain the switch's IPv4 address and
subnet mask, or the IPv6 address.
The management port (mgmt0) is autosensing and operates in full-duplex mode at a speed of
10/100/1000 Mbps. Autosensing supports both the speed and the duplex mode. On a Supervisor-1
module, the default speed is 100 Mbps and the default duplex mode is auto. On a Supervisor-2 module,
the default speed is auto and the default duplex mode is auto.
Note
You need to explicitly configure a default gateway to connect to the switch and send IP packets or add a
route for each subnet.
Configuring Management Interfaces
To configure the mgmt0 Ethernet interface to connect over IPv4, follow these steps:
Command
Step 1
switch# config terminal
switch(config)#
Step 2
switch(config)# interface mgmt0
switch(config-if)#
Step 3
switch(config-if)# ip address 10.16.1.2
255.255.255.0
Step 4
switch(config-if)# no shutdown
Step 5
switch(config-if)# exit
switch(config)#
Step 6
switch(config)# ip default-gateway 1.1.1.4
Cisco MDS 9000 Family CLI Configuration Guide
13-40
Receive B2B Credit performance buffers is 48
12 receive B2B credit remaining
0 transmit B2B credit remaining
About Management Interfaces, page 13-40
Configuring Management Interfaces, page 13-40
Displaying Management Interface Configuration, page 13-41
Chapter 13
Purpose
Enters configuration mode.
Selects the management Ethernet interface on the
switch and enters interface configuration submode.
Configures the IPv4 address and IPv4 subnet mask.
Enables the interface.
Returns to configuration mode.
Configures the default gateway IPv4 address.
OL-18084-01, Cisco MDS NX-OS Release 4.x
Configuring Interfaces
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
