Leds On The Storage Services Module; Port Fibre Channel Advanced Services Module - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual
Cisco mds 9200 series hardware installation guide (ol-16188-01, april 2008)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Messages manual (518 pages)
Table of Contents
Advertisement
Services Modules
LEDs on the Storage Services Module
Table 1-9
Table 1-9
LED
Status
Speed
Link
32-Port Fibre Channel Advanced Services Module
The Cisco MDS 9000 Family 32-port Fibre Channel Advanced Services Module (ASM) enables pooling
of heterogeneous storage for increased storage utilization, simplified storage management, and reduced
total cost of storage ownership. The ASM incorporates all the capabilities of the Cisco MDS 9000
DS-X9032 Fibre Channel switching module and also provides scalable, in-band storage virtualization
services. The ASM module makes it possible to allocate bandwidth optimally.
Cisco MDS 9200 Series Hardware Installation Guide
1-28
describes the LEDs for the Cisco MDS 9000 Family Storage Services Module.
LEDs for the Cisco MDS 9000 Family Storage Services Module
Status
Green
Orange
Red
On
Off
Solid green
Steady flashing
green
Intermittent
flashing green
Solid yellow
Flashing yellow
Off
Description
All diagnostics pass. The module is operational (normal
initialization sequence).
One of the following occurs or occurred:
The module is booting or running diagnostics (normal
•
initialization sequence).
•
The inlet air temperature of the system exceeded the
maximum system operating temperature limit (a minor
environmental warning). To assure maximum product life,
you should immediately correct the environmental
temperature and restore the system to normal operation.
One of the following occurs or occurred:
The diagnostic test failed. The module is not operational
•
because a fault occurred during the initialization sequence.
he inlet air temperature of the system exceeded the safe
•
T
operating temperature limits of the card (a major
environmental warning). The card shut down to prevent
permanent damage.
2-Gbps mode.
1-Gbps mode.
Link is healthy.
Link is healthy and beacon is enabled.
Link is up and traffic is flowing through port.
Link is disabled by software.
A fault condition exists.
No link.
Chapter 1
Product Overview
OL-16188-01
Advertisement
Table of Contents
