Leds On The Generation 2 Switching Modules; Port 2-Gbps Fibre Channel Switching Module - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual
Cisco mds 9200 series hardware installation guide (ol-16188-01, april 2008)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Messages manual (518 pages)
Table of Contents
Advertisement
Switching Modules
LEDs on the Generation 2 Switching Modules
Table 1-4
Modules and the 4-port 10-Gbps Fibre Channel Switching Module.
Table 1-4
LED
Status Green
Link
32-Port 2-Gbps Fibre Channel Switching Module
The 32-port 2-Gbps Fibre Channel switching module can be used to allocate bandwidth optimally. The
module is organized into eight four-port groups. Only the first port in each four-port group can be an
ISL. If the first port is an ISL, the other three ports in the group are disabled. The four ports within a port
group share a single internal channel resulting in a subscription ratio of approximately 3.2:1. The 32-port
2-Gbps switching module provides more ports at a lower price per port.
switching module.
Cisco MDS 9200 Series Hardware Installation Guide
1-16
describes the LEDs for the 48-port, 24-port, and 12-port 4-Gbps Fibre Channel Switching
LEDs for the Cisco MDS 9000 Family Generation 2 Fibre Channel Switching Modules
Status
Description
All diagnostics pass. The module is operational
(normal initialization sequence).
Orange
One of the following occurs or occurred:
The module is booting or running diagnostics
•
(normal initialization sequence).
•
The inlet air temperature of the system has
exceeded the maximum system operating
temperature limit (a minor environmental
warning). To ensure maximum product life, you
should immediately correct the environmental
temperature and restore the system to normal
operation.
Red
One of the following occurs or occurred:
The diagnostic test failed. The module is not
•
operational because a fault occurred during the
initialization sequence.
•
he inlet air temperature of the system has
T
exceeded the safe operating temperature limits of
the card (a major environmental warning). The
card has been shut down to prevent permanent
damage.
Solid green
Link is up.
Intermittent
Link is up (traffic on port).
flashing green
Solid yellow
Link is disabled by software.
Flashing
A fault condition exists.
yellow
Off
No link.
Chapter 1
Product Overview
Figure 1-13
shows a 32-port
OL-16188-01
Advertisement
Table of Contents
