Installing A Power Supply - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual
Cisco nexus 5000 series hardware installation guide (ol-15902-01, november 2008)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Messages manual (518 pages)
Table of Contents
Advertisement
Removing and Installing Components
S e n d d o c u m e n t a t i o n c o m m e n t s t o n e x u s 5 k d o c s @ c i s c o . c o m
Install a blank power supply filler panel if the power supply bay is to remain empty.
Step 4
Figure 2-11
Figure 2-12
Installing a Power Supply
To install a power supply, follow these steps:
Step 1
Ensure that the system (earth) ground connection has been made. For ground connection instructions,
see the
Cisco Nexus 5000 Series Hardware Installation Guide
2-22
Removing the Power Supply for the Cisco Nexus 5020 switch
Removing the Power Supply for the 5010
"Grounding the System" section on page
Chapter 2
Installing the Cisco Nexus 5000 Switch
2-10.
OL-15902-01
Advertisement
Table of Contents
