Table of Contents
Advertisement
Using the WBPN Wireless-N Bridge for Phone Adapters Configuration Utility
Configuring Wired Parameters
Configuring Wired Parameters
STEP 1
STEP 2
TIP
Cisco WBPN User Guide
State
Data Rate
RSSI
Region
Send Packets
Received Packets
Reset Counter
Cisco recommends using the Setup Wizard to configure the WBPN. However, the
Navigation Menu can also be used for configuration.
Configuring LAN Settings
From the Navigation Menu, choose Wired > LAN IP Address.
IP Settings
Under
, choose Automatic (DHCP) if you want your network router to
assign an IP address to the WBPN when it is connected to the network. This IP
address can change if the device is disconnected and connected again.
Choose Static IP if you want the WBPN to always have the same IP address on the
network. Enter the IP address you want to assign to the WBPN, the subnet mask,
and the default gateway (the IP address of your network router).
If you choose DHCP or you change the IP address to an address that is different
from the default IP address, you will need to use that new address if you want to
connect your PC to the device later for additional configuration.
State of the wireless network (for example, disabled or
connected).
Rate of data transmission, in megabits per second
(Mbps).
Received signal strength indicator of the wireless
signal received from the router or AP.
Geographical region in which the WBPN is intended for
operation.
Packets that have been transmitted over the wireless
interface from the WBPN to the network.
Packets that have been received by the WBPN on the
wireless interface from the network.
Click to reset the send and received packet counters.
2
23
- Quick Links:
- Connecting the Wbpn Using a Pc
Hide quick links:
Advertisement
Table of Contents
