Installation To Threaded Rod; Installation To Extension Column - NEC LT30 - XGA DLP Projector Installation And Assembly Manual
Lt30/35 cm guide
Hide thumbs
Also See for LT30 - XGA DLP Projector:
- Specifications (2 pages) ,
- Control commands (54 pages)
Table of Contents
Advertisement
Installation to Threaded Rod
Attach projector mount assembly (A) to two 3/8-16 threaded rods (not included) using two 3/8-16 hex thin nylon-
insert locknuts (not included) as shown in figure 1.1 or figure 1.2.
Skip to step 6.
3/8 -16 THREADED ROD
(NOT INCLUDED)
3/8 -16 HEX THIN
NYLON-INSERT
LOCKNUT
(NOT INCLUDED)
Installation to Extension Column
Screw projector mount assembly (A) onto extension column (sold separately) as shown in figure 2.1. Note: For
3/4" extension columns, reducer ACC 913 will be required as shown in figure 2.2. Tighten swivel stop screw
against extension column or reducer using 4 mm security t-wrench (B). Note: Swivel stop screw is used to jam
against threads of extension column or reducer to prevent any excess movement of projector mount assembly
(A). Do not overtighten screw; overtightening screw will damage threads making it difficult to separate products.
Skip to step 6.
A
SWIVEL STOP SCREW
fig. 2.1
Visit the Peerless Web Site at www.peerlessmounts.com
A
fig. 1.1
1 1/2" EXTENSION
COLUMN
BACK OF
MOUNT
3/8 -16 THREADED ROD
(NOT INCLUDED)
A
FRONT OF
MOUNT
3/8 -16 HEX THIN
NYLON-INSERT
LOCKNUT
(NOT INCLUDED)
A
SWIVEL STOP SCREW
5 of 7
For customer service call 1-800-729-0307 or 708-865-8870.
fig. 1.2
3/4" EXTENSION COLUMN
ACC 913
BACK OF
MOUNT
fig. 2.2
ISSUED: 10-13-05 SHEET #: 055-9445-2 03-31-06
FRONT OF
MOUNT
Advertisement
Table of Contents
