Figure 2-10 Attaching Grounding Wire To Grounding Lug - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Hardware Installation Manual
11500 series content services switch
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Configuration manual (432 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Chapter 2
Cabling and Troubleshooting the CSS
3.
Figure 2-10 Attaching Grounding Wire to Grounding Lug
4.
5.
6.
7.
8.
78-13884-06
Insert the stripped end of the grounding wire into the open end of a lug
(Figure
2-10) and crimp the grounding lug securely to the wire. Use the lug
manufacturer's recommended crimping tool and crimping procedure to
ensure a proper crimp.
Stripped wire
Attach the grounding lug firmly to the threaded holes on the chassis using two
M5 screws.
On the CSS 11503 chassis, the holes are located on the left side (looking
•
from the rear) near the bottom rear corner.
On the CSS 11506 chassis, the holes are located on the right rear panel.
•
The three threaded holes are unevenly spaced to accommodate different lugs.
Strip the covering from the other end of the grounding wire. See the table in
step 2 for strip lengths for different lugs.
Insert the stripped end of the grounding wire into the open end of a grounding
lug and crimp the grounding lug securely to the wire.
Attach the grounding lug to an appropriate grounding point at your site.
Proceed to the
"Connecting the Power Cord"
Cisco 11500 Series Content Services Switch Hardware Installation Guide
Connecting the Chassis to Ground
Grounding lug
section.
2-25
Advertisement
Table of Contents
Troubleshooting
