Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Hardware Installation Manual page 31
11500 series content services switch
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Configuration manual (432 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Chapter 1
Unpacking and Installing the CSS
•
•
Use the following guidelines when you work with any equipment that is
connected to telephone wiring or other network cabling, even if that equipment is
disconnected from its power source.
•
•
•
•
Do not work on the system or connect or disconnect cables during periods of
Warning
lightning activity.
Before you work on equipment that is connected to power lines, remove jewelry
Warning
(including rings, necklaces, and watches). Metal objects will heat up when
connected to power and ground and the heat can cause serious burns or weld
the metal object to the terminals.
Warning
Read the installation instructions before you connect the system to its power
source.
78-13884-06
Do not perform any action that creates a potential hazard to people or makes
the equipment unsafe. Never install equipment that appears damaged.
Carefully examine your work area for possible hazards such as moist floors,
ungrounded power extension cables, and missing safety grounds.
Never install telephone wiring during a lightning storm.
Never install a telephone jack in a wet location unless the jack is specifically
designed for wet locations.
Never touch uninsulated telephone wires or terminals unless the telephone
line has been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
Cisco 11500 Series Content Services Switch Hardware Installation Guide
Safety Guidelines
1-5
Advertisement
Table of Contents
Troubleshooting
