Table of Contents
Advertisement
Chapter 14
Configuring Filters
Figure 14-5 Ethertype Filters Page
Follow this link path to reach the Ethertype Filters page:
1.
2.
3.
Creating an Ethertype Filter
Follow these steps to create an Ethertype filter:
Follow the link path to the Ethertype Filters page.
Step 1
If you are creating a new filter, make sure <NEW> (the default) is selected in the Create/Edit Filter Index
Step 2
menu. To edit an existing filter, select the filter number from the Create/Edit Filter Index menu.
In the Filter Index field, name the filter with a number from 200 to 299. The number you assign creates
Step 3
an access control list (ACL) for the filter.
Step 4
Enter an Ethertype number in the Add Ethertype field. See
protocols and their numeric designators.
Step 5
Enter the mask for the Ethertype in the Mask field.
Step 6
Select Forward or Block from the Action menu.
Step 7
Click Add. The Ethertype appears in the Filters Classes field. To remove the Ethertype from the Filters
Classes list, select it and click Delete Class. Repeat
OL-4059-01
Click Services in the page navigation bar.
In the Services page list, click Filters.
On the Apply Filters page, click the Ethertype Filters tab at the top of the page.
Configuring Filters Using the Web-Browser Interface
Step 4
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
Appendix B, "Protocol Filters,"
through
Step 7
to add Ethertypes to the filter.
for a list of
14-9
Advertisement
Table of Contents
