Cisco 7606-S Installation Manual page 81
Field-replaceable units (frus)
Hide thumbs
Also See for 7606-S:
- Configuration manual (742 pages) ,
- User manual (446 pages) ,
- Installation manual (324 pages)
Table of Contents
Advertisement
Chapter 5
Removal and Replacement Procedures
Figure 5-80 DC-Input Wire Connections for 6000-W DC-Input Power Supply for Left Side of Power Bay
Input power
Power leads
attached to
terminal block
( - ) Negative
(+) Positive
( - ) Negative
(+) Positive
( - ) Negative
(+) Positive
( - ) Negative
(+) Positive
b.
From the left side of the power supply, connect each of the DC-input wires to the terminal block
(Figure 5-77
Note
Wire for 2800 W (right side of power supply bay) as follows:
Step 9
From the right side of the power supply, connect the ground wire to the ground
a.
OL-4503-24
module
Power
CI SC O SY
ST EM S, IN
C
switch
Captive
installation
screw
and
Figure
5-80) in this order:
Negative (-)
Positive (+)
When you tighten the terminal nuts, make sure they are snug. Do not over tighten them.
Recommended torque strength is 20 inch-pounds. Over tightening the terminal nuts can
break the terminal block (Maximum torque: 36 inch-pounds).
Terminal
block cover
1
2
3
IN PU T
4
OK
FA N
OU TP UT
OK
FA IL
( ) Ground
Cisco 7600 Series Router Installation Guide
Removing and Replacing the Power Supply
(Figure
5-81).
5-81
Hide quick links:
Advertisement
Table of Contents
