Cisco 7606-S Installation Manual page 56
Field-replaceable units (frus)
Hide thumbs
Also See for 7606-S:
- Configuration manual (742 pages) ,
- User manual (446 pages) ,
- Installation manual (324 pages)
Table of Contents
Advertisement
Removing and Replacing the Power Supply
Figure 5-59 DC-Input Wires on Left Side
Installing a PWR-2700-DC Power Supply in a Cisco 7606-S Router
Warning
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Follow these steps to install a DC-input power supply:
Ensure that the system (earth) ground connection has been made. For ground connection installation
Step 1
instructions, see the
Remove the plastic bag attached to the front panel and put aside. This bag contains two plastic terminal
Step 2
block barriers, two cable ties, and two cable holder covers.
Step 3
Verify that power is off to the DC circuit connected to the power supply you are installing.
Grasp both power supply handles, as shown in
bay. Make sure that the power supply is fully seated in the bay.
Cisco 7600 Series Router Installation Guide
5-56
P W R -2
7 0 0 -D C
/6
C H A S S
IS
G R O U
N D
A LL FA
S TE N E
P R IO R
R S M U
TO O P
S T B E
E R A TI
FU LL Y
N G TH
E N G A
E P O W
G E D
E R S U
P P LY
"System Ground Connection" section on page
Figure
Chapter 5
Removal and Replacement Procedures
IN P U T1
IN P U T2
O K
FA N
O U TP U
O K
48 V- 60
T
O K
V
48 V- 60
FA IL
=4 0A
V
=4 0A
3-19.
5-60. Slide the power supply into the power supply
OL-4503-24
Hide quick links:
Advertisement
Table of Contents
