Cisco 7606-S Installation Manual page 25
Field-replaceable units (frus)
Hide thumbs
Also See for 7606-S:
- Configuration manual (742 pages) ,
- User manual (446 pages) ,
- Installation manual (324 pages)
Table of Contents
Advertisement
Chapter 5
Removal and Replacement Procedures
When installing the unit, the ground connection must always be made first and disconnected last.
Warning
Figure 5-28 DC-Input Wire Connections on the Terminal Block
Power leads
attached to
terminal block
( - ) Negative
(+) Positive
( ) Ground
Power
switch
Loosen the captive installation screws on the power supply
Step 5
Caution
Use both hands to install and remove power supplies. Each WS-CDC-2500W DC-input power supply
weighs 22 pounds (9.9 kg).
Grasp the power supply handle with one hand and slide the power supply part of the way out of the
Step 6
chassis. Place your other hand underneath the power supply, as shown in
power supply completely out of the chassis.
OL-4503-24
DC-input cable
I
0
INP UT
FAN
OU TPU T
OK
OK
FAI L
Captive
installation
screw
Removing and Replacing the Power Supply
(Figure
5-28).
Figure
5-29, and slide the
Cisco 7600 Series Router Installation Guide
5-25
Hide quick links:
Advertisement
Table of Contents
