Cisco 7606-S Installation Manual page 19
Field-replaceable units (frus)
Hide thumbs
Also See for 7606-S:
- Configuration manual (742 pages) ,
- User manual (446 pages) ,
- Installation manual (324 pages)
Table of Contents
Advertisement
Chapter 5
Removal and Replacement Procedures
Grasp both power supply handles, as shown in
Step 7
of the chassis.
Figure 5-21 Handling a DC-Input Power Supply
If the power supply bay is to remain empty, install a blank power supply filler plate (Cisco part number
Note
700-03104-01) over the opening, and secure it with the captive installation screws.
Removing PWR-2700-DC Power Supply from a Cisco 7606-S Router
Warning
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
Voltage is present on the backplane when the system is operating. To reduce risk of an electric shock,
keep hands and fingers out of the power supply bays and backplane areas.
Follow these steps to remove a DC-input power supply:
Verify that power is off to the DC circuit connected to the DC-input power supply you are removing.
Step 1
Remove the four screws securing the terminal block cover, and slide the cover off the terminal block
Step 2
(Figure
OL-4503-24
CH AS SI
S
GR OU
ND
5-22).
Figure
5-21, and slide the power supply completely out
P W R -2
7 0 0 -D C
/6
-V E- 1
IN PU T1
IN PU T2
OK
OK
48 V- 60
V
48 V- 60
=4 0A
=4 0A
-V E- 1
-V E- 2
CH AS SI
S
GR OU
ND
-V E- 2
AL L FA
ST EN ER
PR IO R
S MU ST
TO OP
BE FU
ER AT IN
LL Y EN
G TH E
GA GE
PO W ER
D
SU PP LY
P W R -2
7 0 0 -D C
/6
-V E- 1
IN PU T1
IN PU T2
OK
FA N
OK
OU TP UT
48 V- 60
V
48 V- 60
OK
FA IL
V
=4 0A
=4 0A
-V E- 1
-V E- 2
-V E- 2
AL L FA
ST EN ER
PR IO R
S MU ST
TO OP
BE FU
ER AT IN
LL Y EN
G TH E
GA GE
PO W ER
D
SU PP LY
Cisco 7600 Series Router Installation Guide
Removing and Replacing the Power Supply
FA N
OU TP UT
OK
FA IL
V
5-19
Hide quick links:
Advertisement
Table of Contents
