Step 5 - Cisco 12406 Installation And Configuration Manual
Configuration guide
Hide thumbs
Also See for 12406:
- Replacement instructions manual (44 pages) ,
- Unpacking instructions manual (16 pages) ,
- Product overview (52 pages)
Table of Contents
Advertisement
Chapter 4
Troubleshooting the Installation
This command sequence saves the new contents of the software configuration
register to NVRAM, but these new settings do not take effect until you reload or
reboot the router.
Enter the show version privileged EXEC command to display the software
Step 5
configuration register value currently in effect. This value will be used the next
time the router reloads. The value is displayed on the last line of the screen
display, as in the following example:
Router# show version
.
.
.
Configuration register is 0x141 (will be 0x102 at next reload)
Save the software configuration register settings as described in the
Step 6
Solving with Subsystems" section on page
Note
Reboot the router.
Step 7
OL-11497-03
Configuration register changes take effect only after the system reloads,
such as when you enter a reload command from the console.
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
Performing Other Configuration Tasks
4-14.
"Problem
4-7
Advertisement
Table of Contents
Troubleshooting
