Table of Contents
Advertisement
Syntax
Table G-3
Call Command Behaviors (continued)
Context
CONFIG_HOLDING: A connected FE is placed
on hold, while the Cisco ATA 186 is entering a
configuration command
DIALING_HOLDING: Cisco ATA 186 user
entering a second phone number to call while
placing a connected call on-hold
CALLING_HOLDING: Cisco ATA 186
waiting for a second far end to response while
placing a connected call on-hold
WAITHOOK_HOLDING: The AFE hangs-up
to disconnect the current call while there is a
WFE being put on-hold
AITHOOK_ALERTING: The AFE hangs-up
while a waiting call is alerting
Cisco ATA 186 Installation and Configuration Guide
G-12
Commands
US*67: CLIR for the next call;*82: CLIP for the next
call;#90v#: Blind transfer to the number specified in
'v'; disconnect the call and goto
PREDIALSweden#31# or *31#: CLIR in the next
call*90*v#: Blind transfer to the number specified in
'v'; disconnect the call and goto PREDIAL
(non-standard)All RegionsR or any unrecognized
sequence: Abort configuration, restarts dial-tone,
and goto to PREDIAL_HOLDING A complete
configuration sequence: Carries out the command,
and goto PREDIAL_HOLDING
Collected digits match a dial-plan rule: Call the new
number, and goto CALLING_HOLDING;R: Aborts
dialing and revert to PREDIAL_HOLDING
R: Cancel the call and revert to
PREDIAL_HOLDING;(ONH: Cancel the call and
transfer the waiting party to the callee, and revert
back to PREDIAL)
R: Retrieve the WFE and goto CONNECTED
W R: Stop CWT, answer the waiting call, and goto
CONNECTED;WFE cancels the call: Stop CWT,
goto WAITHOOK;ONH: Goto IDLE (in which
Cisco ATA 186 automatically starts ringing the
phone, and goto RINGING)
Appendix G
Call Commands
OL-1267-01
Advertisement
Table of Contents
Troubleshooting
