Table of Contents
Advertisement
Modifying DHCP Settings
Enabling DHCP
Using the Phone Configuration Web Page (Cisco IP Phone Models 7902G/7905G/7912G)
Step 1
Step 2
Step 3
Using the Phone's Network Configuration Screen (Cisco IP Phone Models 7905G/7912G)
Step 1
Step 2
Step 3
Cisco IP Phone Administration Guide for Cisco CallManager 3.3, Cisco IP Phones 7902G/7905G/7912G
4-10
Cisco IP Phones enable DHCP by default, but you can reset the protocol if it
becomes disabled.
Procedure
Open the Phone Configuration web page.
Open your web browser and enter the following URL, where IPaddress is the
a.
IP address of your phone
http://IPaddress
b.
Press Enter.
The Phone Configuration web page appears.
In the pane on the left under Change Configuration, click Network Parameters.
You may be prompted to enter a password.
The Network Parameters web page appears.
To enable DHCP, enter 1 in the DHCP field and click Apply.
On the Cisco IP Phone 7902G, you can also review phone settings using the IVR
system. See the
"Using the Interactive Voice Response (IVR) System on the
Cisco IP Phone 7902G" section on page
Procedure
Press the Menu button.
Use the Navigation button to select Settings, and then press the Select softkey.
From the Settings menu, use the Navigation button to select Network
Configuration, and then press the Select softkey.
Chapter 4
Configuring Network Settings on the Cisco IP Phone
A-22.
OL-6313-01
Advertisement
Table of Contents
Troubleshooting
