Table of Contents
Advertisement
Identifying the Cisco CallManager TFTP Server
Identifying the Cisco CallManager TFTP Server
Step 1
Step 2
Step 3
Step 4
Changing the Cisco CallManager Device Name
Step 1
Step 2
Step 3
Step 4
Cisco VG248 Analog Phone Gateway Software Configuration Guide
3-2
The VG248 uses the TFTP server to identify the correct Cisco CallManager
system. If you are using DHCP, the VG248 attempts to obtain the TFTP server
address from the DHCP server. Or, you can select a different TFTP server by
modifying this setting. If you are not using DHCP, or if your DHCP server is not
configured with a TFTP server address, you should identify the TFTP server using
this setting.
To assign a TFTP server, perform these steps:
From the main menu, choose Configure.
Choose Telephony.
Choose CallManager TFTP server.
Enter the IP address or host name of the TFTP server.
The VG248 uses the Cisco CallManager device name when registering ports with
Cisco CallManager. The actual device name used is the value shown for this menu
option followed by the port number. By default, this is set to "VGC" followed by
10 digits of the VG248's MAC address. For example, port one would use
VCGxxxxxxxxxx01 as its device name, where xxxxxxxxxx are the last 10 digits
of the MAC address.
You can change the default device name, but you must use the standard format
described in the
"Using Auto-Registration" section on page
.From the main menu, choose Configure.
Choose Telephony.
Choose CallManager device name.
Enter the new device name.
Chapter 3
Configuring the Telephony Settings on the VG248
4-2.
OL-1209-02
- Quick Links:
- Accessing Configuration Options
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
