Advertisement
Quick Links
Quick reference guide
PROGRAMME SELECTION BUTTON
Press button "P" (repeatedly) until the indicator of the required programme lights up (see "Table of programmes"
ON
below).
BUTTON
OFF
START BUTTON
BUTTON
The indicator lights up during operation, flashes when a fault occurs and goes off at the end of the programme.
START BUTTON RESET FUNCTION
Press this button for at least 2 seconds; the selected programme and options are cancelled. Main failure displays
(repeated flashing of the START indicator lamp) can be cancelled by RESETTING. Detailed instructions are given in
chapter "What to do if...".
Table of programmes
P
Programmes
https://whirlpooldishwasherusermanual.wordpress.com/
1
Pre-Wash
cold
2
Quickwash
40°C
2)
3
50°C
Eco
4
Daily
60°C
5
Intensive
70°C
1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programmes as a result of the appliance's automatic calibration system.
2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
"nk_customer@whirlpool.com".
Get More Manual http://www.pdflook.com/
Deter-
gent
Loading instructions
Crockery to be washed later.
—
Lightly soiled crockery, with no
dried-on food. * Use of tablets
X *
not recommended.
Normally soiled crockery.
X
Energy-saving programme.
Normally or heavily soiled
X
crockery.
Recommended programme for
heavily soiled crockery, especially
X
suitable for pots and pans.
BEFORE USING THE APPLIANCE FOR THE
FIRST TIME CAREFULLY READ THIS QUICK
REFERENCE GUIDE AND THE ASSEMBLY
INSTRUCTIONS! THE GUARANTEE IS NOT
APPLICABLE IF FAULTS ARE CAUSED BY
INCORRECT USE OF THE APPLIANCE.
Consumption
1)
Litres
kWh
Minutes
5.0
0.02
10
13.0
0.70
30
15.0
1.05
165
16.0
1.35
120
17.0
1.65
145
ADG 7445
5019 396 01802
Chart
GB -1-
Advertisement
Related Manuals for Whirlpool ADG 7445
Summary of Contents for Whirlpool ADG 7445
- Page 1 2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test and other tests, contact the following address: ADG 7445 5019 396 01802 “nk_customer@whirlpool.com”.
- Page 2 First time use How to set detergent type: powder/gel/tablet (if option is available) In order to always ensure the best cleaning 1. Select 3rd programme 2. Press START button 3a. Check your 3b..and set it on your dishwasher 4. Remember to use salt and rinse 5.
- Page 3 Daily check Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft”!) Visual indicator (depending Add salt Visual indicator Fill the salt on model). Screw on the cap. (never add (depending reservoir with Salt residues around cap detergent!).
- Page 4 How to load the racks How to load UPPER RACK (In some models only) B - Adjustable flaps: In horizontal position for cups/long utensils, (In some models only) in raised position for plates and stemware. A - Multipurpose support: Different positions for long C - Cutlery basket: It can be placed in the upper rack when the utensils, cups and glasses.
- Page 5 Select programme Quick, permanent or alternating Overview of programmes The max. possible number of programmes is illustrated in the chapter “Chart”. The corresponding programmes for your appliance can be found on the panel (page 1). Choose programme according to the attached table of programmes (page 1). Duration of the programme depends on the external conditions in the apartment, temperature and pressure etc.
- Page 6 What to do if... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance...
- Page 7 What to do if... Crockery and cutlery... Possible causes... Solutions..salt indicator lit - Use tablets for soft water. - Set “Detergent type” option; if this option is not available, it is normal for the salt indicator to light up..have deposits: regeneration salt residue - In areas with very hard water, more regeneration salt needs to be added (see page 2 “How to set water - Water too hard.
- Page 8 What to do if... Disconnect the mains plug If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the After-sales Service (see warranty). Before contacting our After-Sales Service, take note of the following: - the description of the fault, - the appliance type and model, - the service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side:...