Table of Contents
Advertisement
Quick reference guide
ON
PROGRAMME SELECTION BUTTON
BUTTON
Press button "P" (repeatedly) until the indicator of the required programme lights up (see "Table of
programmes" below).
OFF
START BUTTON
BUTTON
The indicator lights up during operation, flashes when a fault occurs and goes off at the end of the programme.
START BUTTON RESET FUNCTION
Press this button for at least 2 seconds; the selected programme and options are cancelled. Main failure
displays (repeated flashing of the START indicator lamp) can be cancelled by RESETTING. Detailed
instructions are given in chapter "What to do if...".
Table of programmes
P
Programmes
1
Pre-Wash
cold
2
Quickwash
40°C
2)
3
50°C
Eco
4
Intensive
70°C
1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programmes as a result of the appliance's automatic calibration system.
2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
"nk_customer@whirlpool.com".
Deter-
gent
Loading instructions
Crockery to be washed later.
—
Lightly soiled crockery, with no
dried-on food. * Use of tablets
X *
not recommended.
Normally soiled crockery.
X
Energy-saving programme.
Recommended programme for
heavily soiled crockery, especially
X
suitable for pots and pans.
BEFORE USING THE APPLIANCE FOR THE
FIRST TIME CAREFULLY READ THIS QUICK
REFERENCE GUIDE AND THE ASSEMBLY
INSTRUCTIONS! THE GUARANTEE IS NOT
APPLICABLE IF FAULTS ARE CAUSED BY
INCORRECT USE OF THE APPLIANCE.
Consumption
1)
Litres
kWh
Minutes
5.0
0.02
10
13.0
0.70
30
15.0
1.05
165
17.0
1.65
145
ADG 7470
5019 396 01787
Chart
GB -1-
Advertisement
Table of Contents
Related Manuals for Whirlpool ADG 7470
Summary of Contents for Whirlpool ADG 7470
- Page 1 2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”. BEFORE USING THE APPLIANCE FOR THE...
-
Page 2: Set Detergent Type
How to set detergent type: powder/gel/tablet (if option is available) In order to always ensure the best cleaning 1. Select 3rd programme results, you NEED to set: (see Table of programmes DETERGENT type and WATER HARDNESS. - page 1) How to set water hardness * only before the first wash or if the water hardness has been changed 1. - Page 3 Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft”!) Visual indicator (depending on model). Unscrew cap. The salt level indicator lamp may remain lit for the duration of several wash cycles. If the water hardness level falls within category (soft), no salt is required.
- Page 4 How to load UPPER RACK (In some models only) A - Multipurpose support: Different positions for long utensils, cups and glasses. How to adjust upper rack height (if available) - It could be useful to lift up upper rack to have more space in lower rack or bring it down to load long stem glasses.
- Page 5 Select programme Quick, permanent or alternating Overview of programmes The max. possible number of programmes is illustrated in the chapter “Chart”. The corresponding programmes for your appliance can be found on the panel (page 1). Choose programme according to the attached table of programmes (page 1). Duration of the programme depends on the external conditions in the apartment, temperature and pressure etc.
-
Page 6: Troubleshooting
If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance..is not working/will not start - The appliance must be switched on. - Page 7 Crockery and cutlery..salt indicator lit - Use tablets for soft water..have deposits: regeneration salt residue - Water too hard. - Salt reservoir cap open. - Not enough rinse aid..are not dry - Plastic containers dry badly. - Clean dishes left in dishwasher for a long time after end of cycle (e.g.
- Page 8 Disconnect the mains plug If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the After-sales Service (see warranty). Before contacting our After-Sales Service, take note of the following: Precautions and general recommendations 1.