Configure Wep (Bridge Mode) - D-Link Xtreme N Duo DAP-1522 User Manual

Wireless bridge

Hide thumbs Also See for Xtreme N Duo DAP-1522:

Table of Contents

Section - Security

It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please

establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption

due to the added overhead.

1. Log into the web-based configuration by opening a web browser and entering the IP address of the bridge

(192.168.0.50). Click on Setup and then click Wireless Settings.

2. For Security Mode in the �ire�e�� Security Mode section,

select WEP.

3. Next to WEP Key Length in the WEP section, selectboththetype

of input (hexidecimal or ASCII) and the level of encryption (64-

bit or 128-bit). Hex - (recommended) Letters A-F and numbers 0-9

are valid. .

4. For the Default WEP Key and the first selection on the drop-down menu, WEP Key 1. Enter a WEP key that you create

For the Default WEP Key and the first selection on the drop-down menu, WEP Key 1. Enter a WEP key that you create

in the WEP Key value and Verify WEP Key value fields. Make sure you enter this key exactly on all your wireless

devices. You may enter up to 4 different keys using the Default WEP Key drop-down menu. .

5. For Authentication, select Open or Shared Key.

6. Click Save Settings to save your settings. If you are configuring the access point with a wireless adapter, you will lose

connectivity until you enable WEP on your adapter and enter the same WEP key as you did on the access point.

D-Link DAP-15 User Manual

Configure WEP (Bridge Mode)

select both the type

Table of Contents

Show Quick Links

Table of Contents