Table of Contents
Advertisement
EBU26866
Drive chain slack
The drive chain slack should be checked before
each ride and adjusted if necessary.
TIP
When checking and adjusting the drive chain
slack, there should be no weight on the ATV and
all tires must be touching the ground.
To check the drive chain slack
1. Place the ATV on a level surface.
2. Move the ATV back and forth to locate the
tightest portion of the drive chain, and then
measure the drive chain slack as shown.
8
Drive chain slack:
25.0–35.0 mm (0.98–1.38 in)
1. Drive chain slack
3. If the drive chain slack is incorrect, adjust it as
follows.
To adjust the drive chain slack
1. Place the ATV on a level surface.
2. Loosen the rear wheel axle pinch bolts.
3. Insert a rod of a diameter of 8 mm (0.3 in) and
a length of 10 cm (4 in) into one of the holes in
the drive chain tensioner as shown.
8-39
Advertisement
Table of Contents
Troubleshooting
