Figure 48. Installing the speakers
Steps
1. Using the alignment posts, place the left and right speakers into their slots on the palm-rest assembly.
2. Route the speaker cable through the routing guides on the palm-rest assembly.
3. Connect the speaker cable to the speaker cable connector (SPK1) on the system board.
NOTE:
Ensure that the rubber grommets are seated into the slot and installed on the speakers properly.
Figure 49. Rubber grommets
Next steps
1. Install the battery.
2. Install the
plastic
filler, if applicable.
3. Install the
assembly-inner
4. Install the
base
cover.
5. Install the
SIM
card.
6. Follow the procedure in
86
Removing and installing Field Replaceable Units (FRUs)
frame.
After working inside your
computer.