Table of Contents
Advertisement
Available languages
Available languages
During Operation
Starting the Machine
1.
Ensure that the battery pack(s) are installed in the machine; refer to
2.
Insert the electric-start button into the electric-start switch (A of
3.
Squeeze the blade-control bar and hold it to the handle for 2 seconds (B of
4.
Press the electric-start button and keep it pressed until the motor starts (C of
Adjusting the Blade Speed
This machine has 2 blade-speed settings: A
M
.
AX
•
When set to the A
UTO
is adjusted automatically for greater efficiency;
changes in cutting conditions are detected and
the blade speed increases when necessary to
maintain quality of cut.
•
When set to the M
AX
remains at the highest speed at all times. The
traction speed of the machine also increases.
Turn the electric-start button in the electric-start switch
to either position to adjust the blade speed setting
(Figure
14).
Figure 14
1. A
position
UTO
UTO
position, the blade speed
position, the blade speed
2. M
position
AX
Figure
Figure 13
Using the Self-Propel Drive
and
To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the machine will automatically keep pace
with you
(Figure
Note:
Use the traction-assist handle in situations
when you need more control than you have with the
self-propel drive alone.
Note:
If the machine does not freely roll backward
after self-propelling, stop walking, hold your hands
in place, and allow the machine to roll a couple of
centimeters (inches) forward to disengage the wheel
drive. You can also try reaching just under the upper
handle to the metal handle and pushing the machine
g337279
forward a couple of centimeters (inches). If the
machine still does not roll backward easily, contact an
Authorized Service Dealer.
13
Installing the Battery Pack (page
13).
Figure
13).
Figure
13).
15).
Figure 15
11).
g426674
g434445
Advertisement
Chapters
Table of Contents
