Priming The Hydraulic Pump - Toro 31050 Service Manual
Hide thumbs
Also See for 31050:
- Service manual (343 pages) ,
- Operator's manual (92 pages) ,
- Operator's manual (92 pages)
Advertisement
Priming the Hydraulic Pump
Hydraulic System: Service and Repairs
When the hydraulic system is flushed or charged or the hydraulic components
are installed, it is important to properly prime the hydraulic pumps. The hydraulic
pump priming ensures that the hydraulic pumps have sufficient fluid during initial
start-up and running. The pump can be primed by using a remote starter switch
(refer to
Special Tools (page
to prime.
Use the following procedure to prime the hydraulic pumps:
1. Ensure that the key switch is in the OFF position and the key is removed
from the key switch.
2. Check the hydraulic-fluid level in the hydraulic tank and add correct quantity
of fluid if necessary; refer to the Operator's Manual.
g216339
1.
Bolt
3. Remove the bolt from the left side of the fuel tank bracket and rotate the fuel
tank to the right to access the engine
Note: You must have the steering wheel rotated to the fully locked position to
rotate the fuel tank out fully.
g293122
1.
Starter motor
2.
Starter solenoid
2–15)) to crank the engine which allows the pump
Figure 63
2.
Fuel tank bracket
(Figure
Figure 64
3.
B+ terminal
Page 5–70
63).
ProLine H800
19241SL Rev B
Advertisement
Chapters
