Advertisement
Operating Instructions
Bedienungsanleitung
_Mode d'emploi
"Istruzioni per uso
"This product is manufactured to comply with the radio inter-
ference
requirements
of
EEC
Directive
76/889/EEC
and
62/499/ EEC."
Thank you for buying this Pioneer product.
Please read these operating instructions thoroughly, so you will know
how to operate your model properly. After you have finished reading
the instructions, put them away in a safe place for future reference.
For the sake of convenience, these operating instructions are based
on the. model HE, and they can be used for the HB, YP, KU, KC, S
and $/G models.
7
The differences between the models are given below.
HE model:
|
For Europe excluding U.K. ("HE' stamped on packing case): Power
line voltage is AC 220 volts.
HB model:
For U.K. ('HB' stamped on packing case): Power line voltage is AC
240 volts.
YP model:
For Australia ("YP' stamped on packing case): Power line voltage is
AC 240 volts.
KU and KC models:
|
For U.S.A.
and Canada
('KU' or 'KC' eee
on packing case):
Power line voltage is AC 120 volts.
S and S/G models:
For destinations excluding above ('S' or 'S/G' stamped on packing
case): A 4-point (110 V/120 V/220 V/240 V) voltage selector switch is
provided.
NOTE:
Depending upon the model, the design of the power plug and the
power outlet differs.
The line voltage selector switch is located on the rear panel of the
unit. Please check that it is set properly before plugging the power
cord into an outlet. If it is not set properly, change the setting ac-
cording to the LINE VOLTAGE SELECTION.
IMPORTANT NOTICE (For KU and KC models)
The serial number for this equipment is located on the rear panel.
Please write this serial number on your enclosed warranty card and
keep in a secure place. This is for your security.
WARNING:
TO PREVENT
FIRE OR
SHOCK HAZARD, DO NOT EXPOSE
THIS
APPLIANCE
TO
RAIN
OR
MOISTURE.
STEREO DOUBLE
CASSETTE
TAPE DECK AMPLIFIER
DC-110Z/DC-111Z
AO mass ga
EP
FM/AM
DIGITAL SYNTH ESIZER TUNER ae oe
TX-220Z/TX-221
TX-220ZL/TX-221ZL suze" 0
AM/FM
STEREO
TUNER
STEREO TURNTABLE
PL-2202/PL-221Z
PL-1102Z/PL-111Z
LINE VOLTAGE
SELECTION
(S and S/G models only)
Before your model is shipped from the factory, the switch is set to the
power
requirements
of the destination:
nevertheless,
you should
check that it is set properly before plugging the power cord into the
AC outlet.
1. Disconnect the power cord.
2. Provide yourself with a medium size screwdriver.
3. Insert the screwdriver into the groove on the voltage selector and
adjust to the voltage value of your area.
Volts
120V
=110V
240 V
220 V
Screwdriver
=
=<
4
a
E
HE (for Europe excluding U.K.), HB (for U.K.), YP (for Australia),
—
KU (for U.S.A.) and KC (for Canada) models are not provided with
a LINE VOLTAGE
SELECTOR
switch.
WPIONEER'
Advertisement
Table of Contents
