Table of Contents
Advertisement
Connect Switch to the Network
•
•
•
•
•
•
•
•
•
Port Connection Guidelines
Depending on the chassis , you can use optical modules and RJ-45 connectors to connect the ports to other
network devices.
To prevent damage to the fiber-optic cables, we recommend that you keep the transceivers disconnected from
their fiber-optic cables when installing the transceiver in the line card. Before removing a transceiver from
the router, remove the cable from the transceiver.
To maximize the effectiveness and life of your transceivers and optical cables, ensure the following:
• Wear an ESD-preventative wrist strap that is connected to an earth ground whenever you handle
• Do not remove and insert a transceiver more often than is necessary. Repeated removals and insertions
• Keep the transceivers and fiber-optic cables clean and dust free to maintain high signal accuracy and to
Hardware Installation Guide for Cisco CQ211L01 Switch
26
Port Connection Guidelines , on page 26
Interfaces and Port Description, on page 27
Connecting a Console to the Router, on page 29
Create the Initial Switch Configuration, on page 30
Connect the Management Interface, on page 32
Install and Remove Transceiver Modules, on page 33
Connect Interface Ports, on page 35
Maintain Transceivers and Optical Cables, on page 36
Verify Chassis Installation, on page 36
transceivers.
can shorten its useful life.
prevent damage to the connectors. Attenuation (loss of light) is increased by contamination. Connector
loss should be kept below 0.35 dB.
• Clean these parts before installation to prevent dust from scratching the fiber-optic cable ends.
• Clean the connectors regularly; the required frequency of cleaning depends upon the environment.
In addition, clean connectors when they are exposed to dust or accidentally touched. Both wet and
dry cleaning techniques can be effective; refer to your site's fiber-optic connection cleaning
procedures.
4
C H A P T E R
Advertisement
Chapters
Table of Contents
