Installing, Connecting And Commissioning - Siemens SIMATIC NET S7-300 - PROFIBUS Equipment Manual
Hide thumbs
Also See for SIMATIC NET S7-300 - PROFIBUS:
- Manual (317 pages) ,
- Operating instructions manual (50 pages) ,
- Manual (68 pages)
Table of Contents
Advertisement
Installation, connection, commissioning, removal
4.3 Installing, connecting and commissioning
Lack of equipotential bonding
If there is no equipotential bonding in hazardous areas, there is a risk of explosion due to
equalizing current or ignition sparks.
• Ensure that equipotential bonding is available for the device.
Unprotected cable ends
There is a risk of explosion due to unprotected cable ends in hazardous areas.
• Protect unused cable ends according to IEC/EN 60079-14.
Insufficient isolation of intrinsically safe and non-intrinsically safe circuits
Risk of explosion in hazardous areas
• When connecting intrinsically safe and non-intrinsically safe circuits, ensure that the
• Observe the device approvals applicable for your country.
Unauthorized repair of devices in explosion-proof design
Risk of explosion in hazardous areas
• Repair work may only be performed by personnel authorized by Siemens.
4.3
Installing, connecting and commissioning
NOTICE
Improper mounting
Improper mounting may damage the device or impair its operation.
• Before mounting the device, always ensure that there is no visible damage to the device.
• Mount the device using suitable tools. Observe the information in the respective section
20
WARNING
WARNING
WARNING
galvanic isolation is performed properly in compliance with local regulations (e.g. IEC
60079-14).
WARNING
about mounting.
Equipment Manual, 05/2023, C79000-G8976-C160-04
CP 343-5
Advertisement
Table of Contents
