Table of Contents
Advertisement
Installation Overview
Figure 56: Mounting Bracket for Wall and Pole Mounting AP with Power Supply
1
One of four keyhole slots to mount the AP.
2
Three of six bracket mount holes for fastening the bracket to a wall. Support bolts of up to 0.25 inch
(6 mm) in diameter
3
Screw holes for fastening the power supply to the bracket
Before you begin
Ensure that you have the following materials before beginning to mount the AP to a wall:
Table 5: Materials Required to Mount AP to a Wall using AIR-MNT-VERT2= Kit
Materials Required
Ground lug and screws (provided with the access point)
Wall Mount Bracket
Four M6 x 12-mm Hex-head Bolts
Four #8-32 screws to mount the power supply
Crimping tool for ground lug, Panduit CT-720 with CD-720-1 die
Four wall mounting screws
#6 AWG ground wire
Shielded outdoor-rated Ethernet (CAT5e or better) cable
Grounding block
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
Vertically Mounting the AP with DC Supply to a Wall
Supplied in the
Kit?
Yes
Yes
Yes
Yes
No
No
No
No
No
45
Advertisement
Table of Contents
