Table of Contents
Advertisement
Getting Started
This chapter contains the following sections:
•
•
•
•
•
•
•
Getting Started with the Configuration
This section describes the system requirements and how to access the web-based Configuration Utility.
Supported Browsers
Before you begin to use the configuration utility, make sure that you have a computer with one of the following
browsers:
• Internet Explorer 11, Microsoft Edge or later
• Firefox 64 or later
• Chrome 72 or later
• Safari 5.1 or later
Browser Restrictions
• If using Internet Explorer 11, configure the following security settings:
Cisco WAP150 Wireless-AC/N Dual Radio Access Point with PoE / Cisco WAP361 Wireless-AC/N Dual Radio Wall Plate Access Point with PoE
Getting Started with the Configuration, on page 1
Using the Access Point Setup Wizard, on page 2
Changing Password, on page 6
TCP/UDP Service, on page 6
System Status, on page 7
Quick Start Configuration, on page 8
Window Navigation, on page 9
• Select Tools, Internet Options and then select the Security tab.
• Next, select Local Intranet and then select Sites.
• Select Advanced and then select Add. Add the intranet address of the WAP device
http://<ip-address> to the local intranet zone. The IP address can also be specified as the
subnet IP address so that all subnet addresses, are added to the local intranet zone.
1
C H A P T E R
1
Advertisement
Table of Contents
