Table of Contents
Advertisement
Email Alert Examples
• From Email Address — Enter the email address to be displayed as the sender of the email. The address is a
255-character string with only printable characters. No address is configured by default.
• Log Duration — Enter the frequency in minutes at which scheduled messages are sent. The range is from 30 to
1440 minutes. The default is 30 minutes.
• Scheduled Message Severity — Select the severity from the drop-down list (Emergency, Alert, Critical, Error,
Warning, Notice, Info or debug) that an event must have for it to be sent to the configuration email address at the
frequency specified by the Log Duration. The default severity is Warning.
• Urgent Message Severity — Select the severity from the drop-down list (Emergency, Alert, Critical, Error,
Warning, Notice, Info or debug) that an event must have for it to be sent to the configured email address immediately.
The default severity is Alert.
Step 3
In the Mail Server Configuration area, configure these parameters:
• Server IPv4 Address/Name — Enter the IP address or host name of the outgoing SMTP server. The server address
must be a valid IPv4 address or host name. The IPv4 address should be in a form similar to xxx.xxx.xxx.xxx
(192.0.2.10).
A host name can consist of one or more labels, which are sets of up to 63 alphanumeric characters. If a host name
includes multiple labels, each is separated by a period (.). The entire series of labels and periods can be up to 253
characters long.
• Data Encryption — Choose the mode of security from the drop-down list (Open or TLSv1) for the outbound email
alert. Using the secure TLSv1 protocol can prevent eavesdropping and tampering during the communication across
the public network.
• Port — Enter the SMTP port number to use for outbound emails. The range is a valid port number from 0 to 65535.
The default port is 465.
• Username — Enter the user name for the email account that will be used to send these emails. Typically (but not
always) the user name is the full email address including the domain (such as Name@example.com). The specified
account will be used as the email address of the sender. The user name can contain in the range of 1 to 64 alphanumeric
characters that includes "@", "-", and "." .
• Password — Enter the password for the email account that will be used to send these emails. The password can be
from 1 to 64 characters.
Step 4
In the Message Configuration area, configure the email addresses and subject line:
• To Email Address 1/2/3 — Enter up to three addresses to receive the email alerts. Each email address must be a
valid address.
• Email Subject — Enter the text to appear in the email subject line. This can be up to a 255-character alphanumeric
string.
Step 5
Click Apply.
Email Alert Examples
The following example shows how to fill in the Mail Server Configuration parameters:
Cisco WAP150 Wireless-AC/N Dual Radio Access Point with PoE / Cisco WAP361 Wireless-AC/N Dual Radio Wall Plate Access Point with PoE
28
System Configuration
Advertisement
Table of Contents
