Table of Contents
Advertisement
7. Hold the blue trigger cap down and rotate the Quick
Stick in a circle to ensure that the chute and deflector
operate smoothly.
5
Connecting the Wire to the
Headlight
Parts needed for this procedure:
1
Cable tie
Procedure
1. Insert the wire connector on the loose end of the wire
straight into the back of the headlight until it is securely
in place
(Figure
18).
1
G016761
Figure 18
1. Plastic clip on wire
connector
2. U-bolt
Note: Ensure that the plastic clip on the wire
connector is on the bottom
2. Secure a cable tie (from the loose-parts bag) around the
wire and the handle about 2.5 cm (1 inch) below the
U-bolt
(Figure
18).
2
3
3. Cable tie
(Figure
18).
6
Checking the Engine-Oil Level
No Parts Required
Procedure
Note: Your machine comes with oil in the engine
crankcase. Before starting the engine, check the oil level
and add oil if necessary.
Refer to
Checking the Engine-Oil Level (page
7
Checking the Tire Pressure
No Parts Required
Procedure
The tires are overinflated at the factory for shipping. Reduce
the pressure equally in both tires to between 116 and 137
kPa (17 and 20 psi).
8
Checking the Skids and
Scraper
No Parts Required
Procedure
Refer to
Checking and Adjusting the Skids and Scraper (page
20).
9
20).
Advertisement
Table of Contents
