hit counter script

Installing The Chute Control Rod; Connecting The Wire To The Headlight - Toro Power Max 1028LE Operator's Manual

Hide thumbs Also See for Power Max 1028LE:
Table of Contents

Advertisement

Installing the Chute Control
Rod
1. Remove the packaging materials from the Quick
Stick.
2. From the operating position, rotate the Quick
Stick so that it is upright and in the center.
3. Press and hold the blue trigger cap down and pull
the lever fully rearward.
Note: The discharge chute and deflector should
face forward. If they do not, press and hold the
blue trigger cap down (but do not move the Quick
Stick), and reach forward and rotate the discharge
chute until it faces directly forward.
4. Align the flattened back end of the long chute
control rod (A) with the flattened front end of the short
rod (B) that extends from the front of the control panel
so that they nest together.
B
5. Hold the long
chute control rod in
this orientation
(you must move it
back to insert it
into the gear) and
insert the front end
of the rod into the
opening in the
back of the chute
gear cover until it
slides into the
chute gear.
6. Align the holes in the nested ends of the rods and
insert 2 carriage bolts through the short rod from the
left side of the snowthrower (as viewed from the
operating position).
7. The 2 carriage bolts (in the loose parts bag) will
go through the holes in the short rod and then through
the holes in the long chute control rod.
8
8. Insert the
cable clip (A) that
supports the
deflector cable (B)
onto the forward
carriage bolt, and
secure the carriage
bolts with locknuts
from the loose
parts bag.
9. Press and hold the blue trigger cap down to
unlock the Quick Stick.
10. Rotate the Quick Stick in a circle to ensure that
the chute and deflector operate smoothly.
Connecting the Wire to the
Headlight
1. Insert the wire connector on the loose end of the
wire straight into the back of the headlight until it is
securely in place.
m-6973
A
m-6969
m-7011
Note: Ensure that the plastic clip on the wire
connector is on the bottom.
2. Secure a cable tie (from the loose parts bag)
around the wire and the handle about an inch
(2.5 cm) below the U-bolt.
3329-776 Rev A
B
A

Advertisement

Table of Contents
loading

This manual is also suitable for:

38642

Table of Contents