Cisco Catalyst 9500 Manual page 156
System management configuration guide, cisco ios xe amsterdam 17.2.x
Hide thumbs
Also See for Catalyst 9500:
- Manual (310 pages) ,
- Configuration manual (223 pages) ,
- Hardware installation manual (122 pages)
Table of Contents
Advertisement
Flow Record 5 - DNS Flow Record
Step 10
Step 11
Step 12
Step 13
Step 14
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
140
Command or Action
match connection server transport port
Example:
Device(config-flow-record)# match
connection server transport port
collect flow direction
Example:
Device(config-flow-record)# collect flow
direction
collect timestamp absolute first
Example:
Device(config-flow-record)# collect
timestamp absolute first
collect timestamp absolute last
Example:
Device(config-flow-record)# collect
timestamp absolute last
collect connection initiator
Example:
Device(config-flow-record)# collect
connection initiator
Configuring Application Visibility and Control in a Wired Network
Purpose
Specifies a match to the transport port of the
server.
Specifies to collect the direction — Ingress or
Egress — of the relevant side — Initiator or
Responder — of the bi-directional flow that is
specified by the initiator keyword in the
collect connection initiator command in the
step below. Depending on the value specified
by the initiator keyword, the flow direction
keyword takes the following values :
• 0x01 = Ingress Flow
• 0x02 = Egress Flow
When the initiator keyword is set to initiator,
the flow direction is specified from the initiator
side of the flow. When the initiator keyword
is set to responder, the flow direction is
specified from the responder side of the flow.
For wired AVC, the initiator keyword is
always set to initiator.
Specifies to collect the time, in milliseconds,
when the first packet was seen in the flow.
Specifies to collect the time, in milliseconds,
when the most recent packet was seen in the
flow.
Specifies to collect the side of the flow —
Initiator or Responder — relevant to the
direction of the flow specified by the collect
flow direction command. The initiator
keyword provides the following information
about the direction of the flow :
• 0x01 = Initiator - the flow source is the
initiator of the connection
For wired AVC, the initiator keyword is
always set to initiator.
Advertisement
Table of Contents
Troubleshooting
