Configuring Mac Address Change Notification Traps - Cisco Catalyst 9500 Manual
System management configuration guide, cisco ios xe amsterdam 17.2.x
Hide thumbs
Also See for Catalyst 9500:
- Manual (310 pages) ,
- Configuration manual (223 pages) ,
- Hardware installation manual (122 pages)
Table of Contents
Advertisement
Administering the Device
Step 3
Step 4
Step 5
Step 6
Configuring MAC Address Change Notification Traps
Follow these steps to configure the switch to send MAC address change notification traps to an NMS host:
Procedure
Step 1
Step 2
Command or Action
mac address-table aging-time [0 |
10-1000000] [routed-mac | vlan vlan-id]
Example:
Device(config)# mac address-table
aging-time 500 vlan 2
end
Example:
Device(config)# end
show running-config
Example:
Device# show running-config
copy running-config startup-config
Example:
Device# copy running-config
startup-config
Command or Action
enable
Example:
Device> enable
configure terminal
Example:
Device# configure terminal
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
Configuring MAC Address Change Notification Traps
Purpose
Sets the length of time that a dynamic entry
remains in the MAC address table after the entry
is used or updated.
The range is 10 to 1000000 seconds. The default
is 300. You can also enter 0, which disables
aging. Static address entries are never aged or
removed from the table.
vlan-id Valid IDs are 1 to 4094.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the
configuration file.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
27
Advertisement
Table of Contents
Troubleshooting
