SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
If the mains power supply cable is damaged, it must be • replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard. Before any maintenance operation, deactivate the appliance • and disconnect the mains plug from the socket. Do not use high pressure water sprays and/or steam to clean •...
• Do not use an extension hose if the inlet hose is machine. Prewash such fabrics by hand before too short. Contact the service centre for the loading them into the washing machine. replacement of the inlet hose. SERVICE • You can extend the drain hose to maximum 400 cm.
PROGRAMME CHART Maximum load Programme Programme description Reference spin Temperature range (Type of load and soil level) speed 30'@30° 1 kg A short cycle for synthetic and delicate items with 30°C 800 rpm light soil level or for items to freshen up. Cotton 7 kg White cotton and coloured cotton.
Page 8
Approximate Energy con- Water con- Remaining programme Programmes Load (kg) sumption sumption (li- duration (mi- moisture (%) (kWh) tre) nutes) Cotton 60°C 1,16 Cotton 40°C 0,61 56,2 Synthetics 40°C 0,45 Delicates 40°C 0,55 Wool/Handwash 0,35 30°C Standard cotton programmes Standard 60°C cot- 0,95 Standard 60°C cot- 0,65...
Page 9
• The drum turns regularly to prevent the laundry If you set also the Extra Rinse function ( ) the creases. appliance adds two or more rinses. • The lid stays locked. You must drain the water The related indicator comes on. to unlock the lid.
If you deactivate the acoustic signals, they continue operate when the appliance has a malfunction. BEFORE FIRST USE 1. Connect the mains plug to the mains socket. 5. Set and start a programme for cotton at the 2. Open the water tap. highest temperature without laundry.
Page 11
• The indicator of the button flashes. a. Touch the button to set the appliance • The display shows the programme duration. to pause. The indicator of button 2. If necessary, change the temperature and the flashes. spin speed or add available options. When you b.
2. Wait a couple of minutes until the indicator maximum spin speed for selected washing programme. goes off. 3. You can open the lid. • Alternatively, touch the button to change the spin speed and then touch the button 4. Close the lid and touch the button again.
STUBBORN STAINS • If your appliance does not have the detergent dispenser with the flap device, add the liquid For some stains, water and detergent is not detergents with a dosing ball (supplied by the sufficient. detergent's manufacturer). We recommend that you pre-treat these stains before you put the items in the appliance.
Page 14
CLEANING THE DETERGENT DISPENSER CLEANING THE DRAIN FILTER Do not clean the drain filter if the water in the appliance is hot. CLEANING THE INLET HOSE AND THE VALVE FILTER 90˚ FROST PRECAUTIONS Do this procedure also when you want If the appliance is installed in an area where the to do the emergency drain.
2. Close the water tap and disconnect the water 8. Disconnect the appliance from the mains inlet hose. socket. 3. Disconnect the drain hose from a sink or WARNING! spigot. 4. Put the ends of the drain and inlet hose in a container.
Page 16
Problem Possible solution The appliance does not fill • Make sure that the water tap is open. with water properly. • Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. •...
Problem Possible solution The washing results are • Increase the detergent quantity or use a different detergent. not satisfactory. • Use special products to remove the stubborn stains before you wash the laundry. • Make sure that you set the correct temperature. •...