Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZWQ 270
Summary of Contents for Zanussi ZWQ 270
- Page 1 User manual Washing machine ZWQ 270 ZWQ 260...
-
Page 2: Product Description
Product description 1. The control panel 2. Lid handle 3. Adjustable levelling feet The control panel 1. Programme selector 4. Lights of cycle progress 2. Temperature selector 5. "Start/Pause" pushbutton 3. Pushbuttons and their functions Dispenser box Prewash Wash Softener (do not fill above the MAX symbol... -
Page 3: Safety Information
Safety Information Please read these points carefully before installing and • The manufacturer cannot be held responsible for any using your appliance. Keep this user manual with your damage resulting from incorrect installation. appliance. Precautions to be taken against frost General safety If your appliance is exposed to temperatures below 0°C, •... -
Page 4: How To Run A Wash Cycle
How to run a wash cycle? Using for the first time • Remove the polystyrene insert and all other items in- side the drum. • Ensure the electrical and water connections com- • Run an initial wash cycle at 90°C, without any washing ply with the installation instructions. -
Page 5: Programmes Table
Press the “Start/Pause” pushbutton : the corresponding End of the programme light will flash green while the appliance is paused. The The washing machine stops automatically, the “Start/ lid can only be opened around 2 minutes after the washing Pause” pushbutton goes out and the light “End of cycle” machine has come to a stop. -
Page 6: Care And Cleaning
Programme / Type of washing Load/Time Possible options Rinses : Hand washed items can be rinsed in this 5,5 kg Rinse hold, Easy iron, Rinse plus programme. 50-60 min Drain : Runs an empty cycle after a Rinse hold (or 5,5 kg Night cycle plus). -
Page 7: Operating Problems
Operating Problems Numerous checks were carried out on your appliance be- function, please refer to the sections below before con- fore it left the factory. However, should you notice a mal- tacting the after-sales service. Problems Causes The washing machine •... -
Page 8: Detergents And Additives
Problems Causes The wash cycle is much too • the water inlet filters are dirty, long: • the power or water supply has been cut off, • the motor overheating detector has been activated, • the water inlet temperature is lower than usual, •... -
Page 9: Installation
WATER PRESSURE Minimum 0,05 MPa (0,5 bar) Maximum 0,8 MPa (8 bar) Connection to water supply Type 20/27 Installation Remove all protective packaging for transit before using for the first time. Keep in case needed for future transit: Transporting a non-secured appliance may damage in- ternal components and cause leakages and malfunctions. - Page 10 or multi-plug adaptor. Ensure that the plug is earthed and that it is in accordance with current regulations. Positioning Position the appliance on a flat and hard surface in a ven- tilated location. Ensure the appliance does not come into contact with the wall or other furniture.
- Page 12 www.zanussi.com...