Table of Contents
Advertisement
1
Adding Fuel to the Machine
No Parts Required
Procedure
Add fuel to the machine before starting it. Refer
to your Operator's Manual for the correct fuel and
procedure.
2
Checking the Engine-Oil
Level
No Parts Required
Procedure
Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
the Operator's Manual.
3
Checking the Tire Pressure
No Parts Required
Procedure
Front and rear tires air pressure specification: 124
kPa (18 psi).
Note:
Check the tire pressure before starting the
machine. Refer to your Operator's Manual for the
correct tire type, correct air pressure needed, and
procedure.
4
Checking the
Hydraulic-Fluid Level
No Parts Required
Procedure
1.
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2.
Move the motion-control levers to the
N
-
EUTRAL
LOCK
Note:
Run the engine at the lowest possible
rpm to purge any air in the system.
Important:
Do not engage the PTO.
3.
Raise the deck to extend the lift cylinders, shut
off the engine, and remove the key.
4.
Raise the seat to access the hydraulic-fluid tank.
5.
Remove the hydraulic-tank cap
1. Hydraulic-tank cap
2. Dipstick
6.
Remove the dipstick and wipe it with a clean rag
(Figure
1).
7.
Place the dipstick into the filler neck, remove it,
and check the fluid level
Note:
If the level is not within the notched area
of the dipstick, add enough high-quality hydraulic
fluid to raise the level to within the notched area.
Important:
Do not overfill.
2
position and start the engine.
(Figure
Figure 1
3. Filler neck
(Figure
2).
1).
g227849
Advertisement
Table of Contents
