Advertisement
Quick Links
Finishing Kit
Foam Marker for Multi Pro 1750 Turf Sprayer
Model No. 125-8120
Note: The Foam Marker Kit is required for the installation
of this product. Contact your Authorized Toro Dealer for
more information.
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
Safety
Note: Determine the left and right sides of the machine
from the normal operating position.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
© 2013—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
Foam-marker bracket
Carriage bolt
U-bolt
Flange nuts (3/8 inch)
Spacer
R-clamp
Register at www.Toro.com.
Safety and Instructional
Decals
Safety decals and instructions are easily
visible to the operator and are located near
any area of potential danger. Replace any
decal that is damaged or lost.
125–8112
1. Right boom
2. Both booms
Qty.
1
1
1
Install the finishing kit bracket.
3
1
1
Original Instructions (EN)
All Rights Reserved *3378-936* A
Printed in the USA
Form No. 3378-936 Rev A
Installation Instructions
3. Left boom
Use
Advertisement
Related Manuals for Toro 125-8120
Summary of Contents for Toro 125-8120
- Page 1 Foam Marker for Multi Pro 1750 Turf Sprayer Model No. 125-8120 Installation Instructions Safety and Instructional Note: The Foam Marker Kit is required for the installation of this product. Contact your Authorized Toro Dealer for Decals more information. WARNING Safety decals and instructions are easily visible to the operator and are located near any area of potential danger.
- Page 2 Procedure Description Qty. Foam marker (sold separately) Attach the foam marker (sold Bolts separately). Nuts (1/4 inch) Wiring harness Switch bracket Install the switches and route the wire Rocker switch harness. Paddle switch Bolts 4. Place the R-clamp onto the bolt and secure the bolt with a flange nut (3/8 inch).
- Page 3 Installing the Switches and Routing the Wiring Harness Parts needed for this procedure: g023899 Wiring harness Figure 4 Switch bracket Rocker switch 7. Secure the cover plate. Paddle switch Bolts Routing the Wiring Harness Installing the Switches Note: Lift the seat to route the wire harness. 1.
- Page 4 1. Ensure that both the left and right boom switches located on the console are in the Off position. 2. Pull out on the red pressure relief tab, and remove the black cap from the tank. 3. Pour the proper amount water into the tank, and then add foam concentrate through the opening in the top of the tank according to the manufacturer’s instructions.