Toro Multi-Pro 5800 Installation Instructions
Step kit for turf sprayer
Hide thumbs
Also See for Multi-Pro 5800:
- Installation instructions manual (34 pages) ,
- Quick start manual (2 pages) ,
- Operator's manual (76 pages)
Advertisement
Quick Links
Step Kit
Multi-Pro 5800 Turf Sprayer
Model No. 130-8230
Model No. 130-8231
This product contains a chemical or chemicals known to the State of California to
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Description
Spacer bracket
Step mount (Model 130-8231)
Hex-head bolt (1/2 x 6 inch)
Locknut (1/2 inch)
Washer (1/2 inch)
Spacer bracket
Step mount (Model 130-8230)
Hex-head bolt (1/2 x 6 inch)
Locknut (1/2 inch)
Washer (1/2 inch)
Step
Hex-head bolt (1/4 x 2-1/4 inch)
Flange nut (1/4 inch)
Washer (1/4 inch)
Register at www.Toro.com.
WARNING
CALIFORNIA
Figure 1
Qty.
1
1
1
1
1
1
1
1
1
1
1
2
2
2
Form No. 3394-879 Rev A
Installation Instructions
Use
Install the left step mount.
Install the right step mount.
Install the step.
Original Instructions (EN)
All Rights Reserved *3394-879* A
Printed in the USA
Advertisement
Related Manuals for Toro Multi-Pro 5800
Summary of Contents for Toro Multi-Pro 5800
- Page 1 Form No. 3394-879 Rev A Step Kit Multi-Pro 5800 Turf Sprayer Model No. 130-8230 Model No. 130-8231 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Installing the Left Step Mount Installing the Right Step Mount (Model 130-8231) (Model 130-8230) Parts needed for this procedure: Parts needed for this procedure: Spacer bracket Spacer bracket Step mount (Model 130-8231) Step mount (Model 130-8230) Hex-head bolt (1/2 x 6 inch) Hex-head bolt (1/2 x 6 inch) Locknut (1/2 inch) Locknut (1/2 inch)
- Page 3 Installing the Step (Model 130-8230 or 130-8231) Parts needed for this procedure: Step Hex-head bolt (1/4 x 2-1/4 inch) Flange nut (1/4 inch) Washer (1/4 inch) Procedure 1. Align the 2 holes in the step with 2 of the holes in the end of the step mount (Figure Note: You can install the step in 1 of 5 positions to...