Table of Contents
Advertisement
Caution
When you remove the tilt cylinder pin, the mount
plate may swing forward, crushing your feet or
hands, or those of bystanders.
Block up the mount plate before removing the tilt
cylinder pin.
2. Remove the bolt securing the upper tilt cylinder pin
(Fig. 4).
3. Using a hammer and punch, remove the tilt cylinder
pin.
1
Figure 4
1. Tilt cylinder
2. Tilt cylinder pin
4. Apply a generous coating of grease to the new pin.
5. Install the new pin into position and secure it with a bolt
(Fig. 5).
Note: Leave the new pin installed, even when you remove
the backhoe.
m–4976
Figure 5
1. New tilt cylinder pin
Installing the TX Series
Traction Unit Backhoe Kit
If you will be using the backhoe with a 400 series (TX)
traction unit, install the tilt cylinder pin included in the kit.
2
3
m–4562
3. Bolt
1
2
2. Bolt
1. Block up the mount plate so that it cannot swing
forward.
Caution
When you remove the tilt cylinder pin, the mount
plate may swing forward, crushing your feet or
hands, or those of bystanders.
Block up the mount plate before removing the tilt
cylinder pin.
2. Remove the bolt and nut securing the upper tilt cylinder
pin on the traction unit (Fig. 6).
3. Using a hammer and punch, remove the tilt cylinder
pin.
4. Install the new pin into position and secure it with the
bolt and nut removed previously, using the middle hole
on the pin (Fig. 6).
5. Grease the pin using the fitting on the tilt cylinder.
Note: Leave the new pin installed, even when the backhoe
is removed.
3
4
5
Figure 6
1. Tilt cylinder
2. Bolt
3. Nut
Greasing the Backhoe
Before using the backhoe for the first time, ensure that all
of the fittings are fully greased; refer to Greasing and
Lubrication, page 17.
9
2
1
m–4911
4. New tilt cylinder pin
5. Middle hole
Advertisement
Table of Contents
