Related Manuals for Toro 22232
Summary of Contents for Toro 22232
- Page 1 Form No. 3461-758 Rev A 30in TurfMaster ® Revolution 60V Lawn Mower Model No. 22232—Serial No. 400000000 and Up Model No. 22232T—Serial No. 400000000 and Up *3461-758* Register at www.Toro.com. Original Instructions (EN)
-
Page 2: Safety-Alert Symbol
It is The safety-alert symbol appears above information designed to use Toro 60V lithium-ion battery packs. that alerts you to unsafe actions or situations and These battery packs are designed to be charged only is followed by the word DANGER, WARNING, or by Toro 60V lithium-ion battery chargers. -
Page 3: Table Of Contents
Troubleshooting ............32 damaged. Replace any damaged or unreadable labels. Use only the battery pack specified by Toro. Using other accessories and attachments may increase the risk of injury and fire. Plugging the battery charger into an outlet that is... - Page 4 Charge the battery pack with only the battery the influence of alcohol or drugs. charger specified by Toro. A charger suitable for Do not use a battery-operated lawn mower in 1 type of battery pack may create a risk of fire rain.
- Page 5 Replace the battery pack with a genuine Sharpen a dull blade on both edges to maintain Toro battery pack only; using another type of balance. Clean the blade and ensure that it is battery pack may cause a fire or risk of injury.
-
Page 6: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal133-8054 133-8054 decal94-8072 94-8072 decal139-5405 139-5405 decal116-7581 1. Parking brake—engage 2. - Page 7 Model 66810 decal144-3175 decal145-8260 144-3175 145-8260 1. Read the Operator’s 3. To shut off the machine, 1. Read the Operator’s 3. Do not expose to rain. Manual. release the bar. Manual. 2. To start the machine, 2. Keep away from open fire squeeze the bar to the or flames.
- Page 8 Model 88605 decal140-8471 140-8471 decal137-9463 137-9463 1. The battery pack is charging. 2. The battery pack is fully charged. 3. The battery pack is over or under the appropriate temperature range. 4. Battery pack charging fault decal116-7583 116-7583 1. Warning—read the Operator’s Manual; do not operate this 4.
-
Page 9: Setup
Setup Important: The battery pack is not fully charged when it is purchased. Before using the machine for the first time, refer to Charging the Battery Pack (page 20). Important: Remove and discard the protective plastic sheet that covers the motor and any other plastic or wrapping on the machine. -
Page 10: Assembling The Grass Bag
Assembling the Grass Bag Mounting the Battery Charger (Optional) No Parts Required Parts needed for this procedure: Procedure Mounting hardware (not included) Procedure If desired, mount the battery charger securely on a wall using the wall-mount key holes on the back of the charger. -
Page 11: Product Overview
Product Overview g429384 Figure 8 1. Battery charger model 2. Battery pack Model 66810 88605 (included with (3 included with Model Model 22232) 22232) Controls g426486 Figure 6 1. Side-discharge deflector 7. Self-propel adjustment 2. Rear deflector 8. Electric-start housing 3. -
Page 12: Attachments/Accessories
Contact your Authorized Service Dealer or authorized Toro distributor or go to www.Toro.com for a list of all approved attachments and accessories. To ensure optimum performance and continued safety certification of the machine, use only genuine Toro replacement parts and accessories. -
Page 13: Before Operation
Operation Before Operation Installing the Battery Pack Important: Use the battery pack only in temperatures that are within the appropriate range; refer Specifications (page 11) Make sure that the vents on the battery are clear of any dust and debris. Lift up the battery-compartment lid (A of Figure 10). -
Page 14: Adjusting The Cutting Height
Adjusting the Cutting Height DANGER Adjusting the height-of-cut could bring your hands into contact with a moving blade and result in serious injury. • Shut off the motor, remove the battery, and wait for all moving parts to stop before adjusting the cutting height. -
Page 15: During Operation
During Operation Starting the Machine Ensure that the battery pack(s) are installed in the machine; refer to Installing the Battery Pack (page 13). Insert the electric-start button into the electric-start switch (A of Figure 13). Squeeze the blade-control bar and hold it to the handle for 2 seconds (B of Figure 13). -
Page 16: Adjusting The Blade Speed
Adjusting the Blade Speed This machine has 3 blade-speed settings: A and L • When set to the A position, the blade speed is adjusted automatically for greater efficiency; changes in cutting conditions are detected and the blade speed increases when necessary to maintain quality of cut. -
Page 17: Engaging The Parking Brake
Engaging the Parking Brake Engage the parking brake by pulling the brake lever up toward the handle (Figure 18). g426580 Figure 18 Disengaging the Parking Brake Disengage the parking brake by pushing the brake lever down away from the handle (Figure 19). -
Page 18: Side-Discharging The Clippings
If the side-discharge chute is on the machine, remove it and install the side-discharge deflector before bagging the clippings; refer to Removing the Side-Discharge Chute (page 19). Installing the Grass Bag Raise and hold up the rear deflector (A of Figure 21). -
Page 19: Operating Tips
Maintain sharp blades throughout the cutting season. Periodically file down nicks on the blades. General Tips • Replace the blades when necessary with original Toro replacement blades. • Review the safety instructions and read this • Mow only dry grass or leaves. Wet grass and manual carefully before operating the machine. -
Page 20: After Operation
After Operation cut below the 51 mm (2 inch) setting unless the grass is sparse or it is late fall when grass growth begins to slow down. Removing the Battery Pack • When cutting grass over 15 cm (6 inches) tall, first mow at the highest cutting-height setting and walk from the Machine slower;... -
Page 21: Cleaning Under The Machine
Slide the battery pack into the charger until it is fully seated (Figure 23). To remove the battery pack, slide the battery backward out of the charger. Refer to the following table to interpret the LED g002275 indicator light on the battery charger. Figure 24 1. -
Page 22: Cleaning The Wheels
Cleaning the Wheels Service Interval: Every 40 hours Remove the rear wheels and clean any debris from the wheel-gear area. g429653 Figure 25 1. Gears After cleaning, apply a small amount of anti-seize to the gears. Note: If you are operating the machine in extreme conditions, cleaning the wheels more frequently than recommended will result in increased gear life. -
Page 23: Maintenance
Maintenance Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Service the blade-drive system. After the first 5 hours • Check the blades and service them, if necessary. • Inspect the blades. Before each use or daily • Check the parking-brake function. •... -
Page 24: Checking The Condition Of The Belts
Checking the Condition of Hold a feeler gauge set between 0.13 and 0.76 mm (0.005 and 0.03 inches) against the wall the Belts and slide it down behind the belt tension spring; refer to Figure Service Interval: Every 50 hours Remove the belt cover (Figure 6) by removing... -
Page 25: Servicing The Blades
If you do not have a blades and have them sharpened or replace torque wrench or are uncomfortable performing them. this procedure, contact an authorized Toro distributor. Examine the blades for sharpness and any wear or damage whenever you run out of fuel; refer to Inspecting the Blades (page 25). - Page 26 Replace the blades when they strike a solid object, shown in Figure are out of balance, bent, or worn. Use only genuine Toro replacement blades. Use a block of wood to hold each blade steady and turn the blade bolt counterclockwise as shown in...
-
Page 27: Changing The Blade-Drive Belt
Installing the Blades WARNING Incorrectly installing the blades could damage the machine or cause an injury to you or bystanders. Install the blades according to the instructions. g016536 Figure 34 Install the first blade so that it is horizontal, along with all mounting hardware as shown in Figure 1. -
Page 28: Changing The Transmission Belt
Remove any debris from under the belt cover. If the grass bag is on the machine, remove it. Refer to Removing the Grass Bag (page 18). Raise and hold up the rear deflector. Remove the rear-viewing window, located under the rear-discharge deflector, by removing the bolt holding it in place (Figure 36). -
Page 29: Adjusting The Parking-Brake Cable
From the front of the machine, remove the belt from the motor pulley and then remove from the transmission pulley. Installing the Transmission Belt While the idler pulley is pulled out of the way, install the new transmission belt placing the belt over the transmission pulley first and then over the motor pulley. -
Page 30: Preparing The Battery Pack For Recycling
If you are located outside of the US 2. Adjustment nut 5. Turn the nut and Canada, please contact your authorized counterclockwise to Toro distributor. loosen the adjustment. 3. Handle (right side) Adjust the tension on the cable (Figure... -
Page 31: Storage
Storage Important: Store the machine, battery pack, and charger only in temperatures that are within the appropriate range; refer to Specifications (page 11). Important: If you are storing the battery pack for the off-season, charge it until 2 or 3 LED indicators turn green on the battery. -
Page 32: Troubleshooting
3. The battery pack is damaged. 3. Replace the battery pack. 4. There is another electrical problem 4. Contact your authorized Toro with the machine. distributor. The machine does not run or does not run 1. Allow the battery pack to dry or wipe it 1. - Page 33 2 attempts, properly dispose of the battery pack at a battery recycling facility. 2. The battery pack is weak. 2. Contact your authorized Toro distributor if the battery is in warranty, or properly dispose of the battery pack at a battery recycling facility.
- Page 34 Notes:...
- Page 35 California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.