Table of Contents
Advertisement
Important:
If you are using this machine above
1500 m (5,000 ft) for a continuous period, ensure
that the High Altitude Kit has been installed
so that the engine meets CARB/EPA emission
regulations. The High Altitude Kit increases
engine performance while preventing spark-plug
fouling, hard starting, and increased emissions.
Once you have installed the kit, attach the
high-altitude label next to the serial decal on the
machine. Contact any Authorized Toro Service
Dealer to obtain the proper High Altitude Kit and
high-altitude label for your machine. To locate
a dealer convenient to you, access our website
at
www.Toro.com
or contact our Toro Customer
Care Department at the number(s) listed in your
Emission Control Warranty Statement. Remove
the kit from the engine and restore the engine to
its original factory configuration when running the
engine under 1500 m (5,000 ft). Do not operate an
engine that has been converted for high-altitude
use at lower altitudes; otherwise, you could
overheat and damage the engine.
If you are unsure whether or not your machine has
been converted for high-altitude use, look for the
following label
(Figure
WARNING
CALIFORNIA
Proposition 65 Warning
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects,
or other reproductive harm.
Use of this product may cause exposure
to chemicals known to the State of
California to cause cancer, birth defects,
or other reproductive harm.
3).
Figure 3
Contents
Introduction ............................................................... 1
Safety ....................................................................... 3
General Safety ................................................... 3
Safety and Instructional Decals .......................... 4
Setup ........................................................................ 5
1 Installing the Handle ........................................ 5
2 Installing the Discharge Chute ......................... 5
3 Installing the Recoil-Start Handle ..................... 6
4 Filling the Engine with Oil ................................. 6
5 Adjusting the Control Cable.............................. 6
Product Overview ..................................................... 7
Specifications .................................................... 7
Attachments/Accessories ................................... 7
Operation .................................................................. 8
Before Operation ................................................... 8
Before Operation Safety ..................................... 8
Filling the Fuel Tank ............................................ 9
Checking the Engine-Oil Level.......................... 10
During Operation ................................................. 10
During Operation Safety ................................... 10
Starting the Engine ............................................11
Engaging the Rotor Blades ............................... 12
Disengaging the Rotor Blades .......................... 12
Shutting Off the Engine..................................... 13
Deflector ....................................................... 13
Clearing a Clogged Discharge Chute ................ 13
Self-Propelling the Snowthrower ...................... 13
Operating Tips ................................................. 14
After Operation .................................................... 14
decal127-9363
After Operation Safety ...................................... 14
Preventing Freeze-up after Use ........................ 14
Maintenance ........................................................... 15
Recommended Maintenance Schedule(s) ........... 15
Maintenance Safety.......................................... 15
Maintenance Safety.......................................... 15
Cable ............................................................ 15
Inspecting the Rotor Blades.............................. 16
Changing the Engine Oil ................................... 16
Servicing the Spark Plug................................... 18
Replacing the Drive Belt ................................... 18
Storage ................................................................... 20
Storage Safety.................................................. 20
Storing the Machine.......................................... 20
2
Hide quick links:
Advertisement
Table of Contents
