Table of Contents
Advertisement
Starting the Engine
Electric-Start Model
Note:
Remove your glove when you push in the primer so that air cannot escape from the primer hole.
Important:
Do not use the primer or the choke if the engine has been running and is hot. Excessive
priming may flood the engine and prevent it from starting.
To use the electric starter (electric-start models only), connect a power cord to the electric-start plug-in first
and then to a ground fault circuit interrupter (GFCI) power outlet. Use only a UL-listed, 16-gauge power cord
recommended for outdoor use that is not longer than 15 m (50 ft).
WARNING
The electrical cord can become damaged, causing a shock or fire.
Thoroughly inspect the electrical cord before plugging it into a power source. If the cord
is damaged, do not use it. Replace or repair the damaged cord immediately. Contact an
Authorized Service Dealer for assistance.
Important:
Run the electric starter no more than 10 times at intervals of 5 seconds on, then 5 seconds
off. Running the electric starter extensively can overheat and damage it. If the engine does not start
after this series of attempts, wait at least 40 minutes to allow the starter to cool before attempting to
start it again. If the engine does not start after the second series of attempts, take the machine to an
Authorized Service Dealer for service.
CAUTION
If you leave the machine plugged into a power source, someone can inadvertently start the
machine and injure people or damage property (electric-start models only).
Unplug the power cord whenever you are not starting the machine.
Figure 12
11
g388239
Hide quick links:
Advertisement
Table of Contents
