Table of Contents
Advertisement
Running Express Setup
When you first set up the switch, you should use Express Setup to enter the initial IP information. This process enables
the switch to connect to local routers and the Internet. You can then access the switch through the IP address for
additional configuration.
Required Equipment
You need this equipment to set up the switch:
Computer with Windows 7/Windows 10/Mac
Web browser (Microsoft Internet Explorer 11, Firefox 46.01 and 47.0, or Microsoft Edge 89.0) with JavaScript
enabled. (Disable pop-up blockers and proxy settings and ensure that your browser is using the English EN-US
language pack.)
Firmware upgrade may fail or will never complete when initiated using a browser language pack other
Note:
than en-US.
A straight-through or crossover Category 5 Ethernet cable to connect your computer to the switch port.
A small paper clip to reach the express setup button.
Note:
Before running Express Setup, disable any wireless client running on your computer.
Express Setup Procedure
To run Express Setup:
1.
Make sure that nothing is connected to the switch.
2.
Connect power to the switch.
See the wiring instructions in the "Grounding the Switch" section and the "Wiring the DC Power Source" section on
page 19.
3.
Power on or reset the IE 1000:
—
Use LEDs to monitor boot progress
Sys Blank: POST
Sys solid: exit post, initializing
Sys and alarm LEDs green: init done
~25 seconds after power-on
Cisco Systems, Inc.
www.cisco.com
27
Advertisement
Table of Contents
